Матеріалознавство
Постійний URI для цього зібранняhttps://repositary.knuba.edu.ua/handle/987654321/1859
Переглянути
6 результатів
Результати пошуку
Документ Complex multifunctional additive for anchoring grout based on alkali-activated portland cement(IOP Publishing, 2020) Krivenko, P. V.; Petropavlovskyi, O. M.; Rudenko, I. I.; Konstantynovskyi, O. P.; Kovalchuk, A. V.Complex multifunctional additive (further, CA) which consists of aluminum powder, surfactant, salt-electrolyte (NaNO3) and calcium sulfate hemihydrate (CaSO4∙0.5H2O) is proposed for ensuring necessary properties of anchoring grouts based on alkali-activated portland cement (further, AAPC) presented by the system «ordinary portland cement clinker - sodium metasilicate». Specified consistency of fresh AAPC mortar along with it strength after hardening are provided by water reducing due to application of modified polyethylene glycol characterized by stability of molecular structure in AAPC hydration medium. CA influence on shrinkage mitigation in AAPC mortar is explained both water-reducing effect and gas release with volume increasing during formation of dispersive-coagulation structure. Expansion of crystallization-condensation structure is ensured due to stress of calcium hydrosulfoaluminate 3CaO∙Al2O3∙3СаSО4∙32H2O and calcium hydronitroaluminate ЗСаО∙А12О3∙Са(NO3)2∙10Н2О which form due to presence of СаSО4∙0,5H2O and NaNO3 in CA. Time matching of gas release with structure formation insures dense microstructure due to filling of pores by hydrated phases that causes lower excess stress during crystallization. CA ensures necessary performances of AAPC anchoring grout: consistency 190 mm; workability retention time 15 min; tensile strength in bending / compressive strength 6.1 / 25.7 MPа and 12.9 / 68.5 MPa in 1 d and 28 d agreeably; adhesion 0.9 MPa; linear extension up to +0.37 mm/m.Документ Alkali activated portland cement with adjustable proper deformations for anchoring application(IOP Publishing Ltd, 2019) Krivenko, P. V.; Rudenko, I. I.; Petropavlovskyi, O. M.; Konstantynovskyi, O. P.; Kovalchuk, A. V.The application of alkali-activated Portland cement (hereinafter AAPC) for anchoring grouts was investigated with obtaining of non-shrinking high performance cementing systems. The AAPC system “ordinary Portland cement clinker – sodium metasilicate” was modified by the complexes of mineral and organic compounds to ensure specified properties of anchoring grouts. It was revealed that the most effective multifunctional additives are represented by the system “salt-electrolyte – surfactant”. Alongside with slowing down of AAPC paste setting time, the effect of compensated shrinkage of AAPC mortar, i.e. expansion within 0.062 mm/m and slight shrinkage within 0.017 mm/m, was ensured when Na2SO4 and NaNO3 were used in the mentioned system respectively. The effect of compensated shrinkage is explained by greater crystallization of ydrosilicates and hydroaluminates, additional formation of sulfate-containing sodium-calcium hydroaluminate (for Na2SO4-based system) and crystalline calcium hydronitroaluminate (for NaNO3-based system). The advantages of the modified AAPC for anchoring application are indicated in thepaper.Документ Вплив органо-мінеральних комплексів на міцність і власні деформації шлаколужних цементів(ОДАБА, 2019) Кривенко, П. В.; Петропавловський, О. М.; Руденко, І. І.; Константиновський, О. П.Запропоновано комплексну органо-мінеральну добавку складу «портландцементний клінкер – електроліт – поверхнево-активна речовина», використання якої в шлаколужному цементі забезпечує сповільнення строків тужавлення, підвищення показників міцності і практично відсутність усадки (0,062 мм/м). Показано особливості роботи портландцементного клінкеру у лужному середовищі, вплив добавок солей різного аніонного типу та луговміщуючих аніоноактивних ПАР на водопотребу, синтез міцності та власні деформації при гідратації та формування структури штучного каменя на його основі. Відмічена перспективність запровадження таких органо-мінеральних комплексів в якості додаткових компонентів шлаколужних цементів для регулювання їх технологічними і фізико-механічними властивостями, у т.ч. для зменшення усадки цементного каменяДокумент Enhancement of alkali-activated slag cement concretes crack resistance for mitigation of steel reinforcement corrosion(EDP Sciences, 2020-04) Krivenko, Pavlo; Petropavlovskyi, Oleh; Kovalchuk, Oleksandr; Rudenko, Igor; Konstantynovskyi, OleksandrThe paper is devoted to mitigation of steel reinforcement corrosion in alkali-activated slag cement (further, AASC) concretes, based on soluble sodium silicates (further, SSS’s), obtained from high consistensy concrete mixes. Enhancement of AASC fine concretes crack resistance due to modification by complex shrinkage-reducing additives (further, SRA’s) based on surfactants and trisodium phosphate Na3PO4.12H2O (further, TSP) was proposed for mitigation of steel reinforcement corrosion. SSS’s were presented by sodium metasilicate (silica modulus 1.0, dry state) and water glass (silica modulus 2.9, density 1400 kg/m3). In case of sodium metasilicate the application of SRA composition “ordinary portland cement clinker – TSP – sodium lignosulphonate – sodium gluconate” provides enhancement of crack resistance starting from early age structure formation with restriction of drying shrinkage from 0,984 to 0,713 mm/m after 80 d. The effect is caused by reduction of water and by higher volume of crystalline hydrates. In turn, SRA presented by compositions “TSP – glycerol” and “TSP – glycerol – polyacrylamide” provide enhancement of AASC fine concretes fracture toughness during late structure formation with increasing ratio of tensile strength in bending to compressive strength up to 37 – 49 % if compare with the reference AASC when water glass is used.Документ The efficiency of plasticizing surfactants in alkali-activated cement mortars and concretes(Transbud-2018, 2018) Runova, Raisa; Gots, Volodymyr; Rudenko, Igor; Konstantynovskyi, Oleksandr; Lastivka, Oles’Functionality of mortar and concrete mixes is regulated by surfactants, which act as plasticizers. The molecular structure of these admixtures can be changed during hydration of alkali-activated cements (AAC). The objective was to determine the chemical nature of plasticizers effective for property modification of mortars and concretes based on AACs with changing content of granulated blast furnace slag from 0 to 100 %. The admixtures without ester links become more effective than polyesters when content of alkaline component increase. The admixtures effective in high alkaline medium were used in dry mixes for anchoring (consistency of mortar 150 mm by Vicat cone; 1 d tensile strength in bending / compressive strength of mortar 6.6 /30.6 MPа) and in readymixed concretes (consistency class changed from S1 to S3, S4 with consistency safety during 60 min; 3 d compressive strength of modified concrete was not less than the reference one without admixtures).Документ 35. The influence of complex additive on strength and proper deformations of alkali-activated slag cements(Trans Tech Publications Ltd, 2019) Krivenko, Pavel; Petropavlovskyi, Oleh; Rudenko, Igor; Konstantynovskyi, OleksandrThe peculiarity of alkali-activated slag cements (further, AASC’s) is increased proper deformations, which can cause increased cracking and reduced durability of structure. The paper is devoted to manage AASC’s proper deformations. The main task was to determine the composition of complex additives (further, CA’s) in system «ordinary portland cement (further, OPC) clinker -mineral compound of different anionic type - surfactant» in presence of sodium metasilicate (further, MS) to affect on hydrated AASC performance while ensuring effective structure of artificial stone by criterion of shrinkage deformations. Comparative analysis of hydrated cement systems "OPC clinker - MS", "OPC clinker - mineral compound - MS" and "OPC clinker - mineral compound - MS - surfactant" showed that the greatest effect on reduction of proper deformations occurs when the mineral compounds relate to electrolytes, i.e. Na2SO4 and NaNO3. Hydrated system is characterized by expansion (+0,062 mm/m) in presence of Na2SO4. Almost no shrinkage is supplied by application of NaNO3 (-0,062 mm/m). The obtained CA’s were tested in AASC. CA in the system “OPC clinker - NaNO3 - surfactant” provides the initial setting 43 min, the end - 65 min with accelerated strength. Investigated AASC can be classified as non-shrinking cement. This phenomena is ensured by increasing density, homogeneity and monolithicity of hydrosilicate formations, as well as due to formation of hydroaluminosilicate structures with different morphology by inclusion of nitrate anions.