Будівництво та цивільна інженерія
Постійний URI для цього зібранняhttps://repositary.knuba.edu.ua/handle/987654321/1219
Переглянути
3 результатів
Результати пошуку
Документ Intumescent fireproof coatintgs based on zeolite-like cement matrices(Wiley, 2023-09) Krivenko Pavel; Guzii Sergii; Rudenko Igor; Konstantynovskyi OleksandrConcrete and reinforced concrete building structures (for example, such as tunnels) lose carrying ability in case of high‐temperature fire action. The aim of the research is to study the prevention of reinforced concrete structures (for example, such as tunnels) under fire action in case of using the proposed coating based on the alkaline aluminosilicate binder, which would not consist of organic components dangerous to health. The ratios between constituent oxides in the binder which ensure the ability to bloat the coating under fire action were determined. The performance properties of developed fire protective coating were defined after artificial aging (cycles of alternate drying and cooling) and fire action: bloating factor ‐ 2.0…5.1, adhesion strength ‐ 6.6…8.0 MPa, compressive strength ‐ 2.3…4.5 MPa, cohesive strength of 1.2…1.5 MPa, thermal conductivity coefficient ‐ 0.042…0.066 W/m‐°C, total porosity ‐ 92…97 %. The temperature at which the coating starts to bloat = 200…250 °C has been developed. The results of the test held in the open air suggested drawing a conclusion that with a coating thickness of 6 mm protection of the reinforced concrete from fragile fracture and from plastic deformations in the metal of the reinforcement they provided under fire exposure for a period of 3 hours.Документ Comparison of influence of surfactants on thermokinetic characteristics of alkali-activated slag cement(Private Company Technology Center, 2021-11-26) Krivenko Pavlo; Rudenko Igor; Konstantynovskyi OleksandrIncreasing the durability of concrete and reinforced concrete structures according to the criterion of crack resistance is a relevant task of construction materials science. To solve this task, this paper proposes effective solutions for adjusting thermofinite characteristics of alkali-activated slag cement (ASC) by using surfactants of various chemical nature in order to control the thermally-stressed state of concrete based on it (ASC concrete). The method of calorimetry was applied to show that the problematic issue is to adjust the structure formation of ASC by anion-active surface-active substances based on complex polyesters. This is predetermined by the instability of the molecular structure of surfactants in the hydration environment of ASC due to the destruction of complex ester bonds as a result of alkaline hydrolysis. Thermokinetic analysis has demonstrated the effectiveness of using anion-active surfactants, which do not contain ester bonds, as regulators of crack resistance of ASC concrete. Simple polyesters and multi-atom alcohols provide the ability to adjust the duration of the induction period while ensuring the required completeness of ASC hydration within a time frame. The effectiveness of cation-active surface-active substances has been shown, which are characterized by the stability of the molecular structure in the hydration environment of ASC and an increased level of adsorbing capacity. The decrease in the effectiveness of surface-active substances has been shown, in terms of the effect on the heat release of ASC, in the following series: alkaline salt of carboxylic acid>salt of the quaternary ammonium compound>simple polyester> polyalcohol>complex polyester. The reported results are important in view of the possibility of effective adjustment of ASC heat release by influencing the structure formation of surfactant with a certain molecular arrangement in order to predictably reduce crack formation in a thermally-stressed state and a corresponding increase in the durability of structures.Документ Design of slag cement, activated by Na (K) salts of strong acids, for concrete reinforced with steel fittings(Private Company Technology Center, 2020-12-31) Kryvenko Pavlo; Rudenko Igor; Konstantynovskyi OleksandrThis paper proposes a technique to prevent the corrosion of steel reinforcement in concrete based on slag cement (SC) activated by Na(K) salts of strong acids (SSA) in the composition of by-pass cement kiln dust (BP). The technique implies using additional modifiers in the form of the Portland cement CEM I 42,5 R and the calcium-aluminate admixture (CAA) С3А∙6H2O. It is shown that adding the Portland cement contributes to enhancing the intensifying influence of BP on the SC hydration, accompanied by an increase in the strength of artificial stone. This effect is predetermined by the formation of hydrosilicates in hydration products with an increased crystallization degree in the form of CSH(I) and C2SH(A). Modifying SC with CAA ensures the intensive formation of low-soluble AFm phases in the composition of hydration products, aimed at reliable binding the SSA anions (Cl-, SO42-) that are aggressive to steel reinforcement. The study result has established the possibility to produce SC, activated by SSA, when using BP, the Portland cement, and CAA. Mathematical methods to plan the experiment were applied to produce an SC composition of "granulated blast furnace slag – BP – Portland cement – CAA", characterized by a strength class of 42.5 and a molar ratio of Cl-/OH- in a porous solution not exceeding 0.6. The resulting properties predetermine the feasibility of using SC in steel-reinforced concrete. The relevance of this work is due to the modern trends in the development of the construction industry. The introduction of cement that contains mineral additives, in particular granulated blast furnace slag, contributes to improving the environment by reducing СО2 emission. The use of such cement as a base of steel-reinforced concrete ensures the increase in their functionality and durability.